Here’s a photo of some leather work I did on the portable altar. The leather is a Lattigo leather, very thick, so I had to compress the leather for the post to have enough clearance to set the snaps. The bottom is fixed, I used Loktite to prevent the screw from coming loose during use.
I added a couple of crosses and rounded the corners. This is VERY easy to do after I figured out how to set the snaps.
What an amazing difference! I’ve read that if you only have one spiral cutterhead in the shop, that you should put it in your planer. After all, don’t you plane to final thickness? Well, I finally installed the Shelix head after buying it over 6 months ago. It took about 4 hours, including several interruptions…
I bought some 4/4 10′ long rough sawn Mahogany the other day. Because I wanted to keep as much of the boards thickness as possible, and knowing how that is difficult to do on a 10′ board using the jointer, I skip planed to get a sense of where the grain was so I could cut…
I was using an unnamed HVLP sprayer to finish up a bookcase, and noticed a lot of debris was in the finish. There was one place where I had good light and, looking closely, could actually see debris being deposited WITH the finish! It turns out the air filter under the HVL P was not…
One very important tool in my shop is my LED flashlight. It’s most important use is for finishing. It has two light levels and a focusing ring that allows me to focus the beam from wide too very narrow. I wished photos could be shown here, but the only way to really see what a…
I have to admit that I went a bit overboard on this one. My original intention was to simply fix a loose door on my mailbox, and this is the result. All cedar with handcut and fitted shingles, and front porch with “glass” windows. I wanted to see how the finish would hold up so…
Subscribe now to keep reading and get access to the full archive.