Flush trim band saw jig

Ever have to trim 1/16″ or 1/8″ from end grain but the piece won’t fit your shooting board, and the table saw is out of the question?

I had this problem on the morning bar doors below where I had to flush trim the ends of the book matched ash (unstained in the photo).

So I came up with a great way to do it, and it was soooo easy.

First, I got a squared block of hardwood. Brought my band saw fence as close to the blade without touching it, and cut a matching kerf halfway up the side of the jig. Then I reversed it and clamped it to my band saw fence with the back of the blade resting against the back of the kerf. That’s all there is to it. I was ready to go!

Then I just rested the edge of the door against the outfeed end of the jig as shown in the photo. I had to make multiple passes, each pass removing a kerf’s width of material until the full edge of the door rode flush against the outfeed end of the jig. I removed the band saw marks with sandpaper.

Easy peasy!

Here’s a short video of one pass.

Similar Posts

Leave a Reply