Altar made with red oak A2 plain sliced plywood, and air dried quarter sawn red oak, with 24 way red oak match veneer sunburst. Red oak columns, capitals and carvings (hand carved), and crown gilding were done by Jorge Posada. Gold accents by Shannon Pable.
This interesting project was the result of being asked to install these 2 solid brass holy water fonts at the entrance to the chapel. The finish matches the dye/stain water based finish used on the altar and interior of the chapel itself. They were mounted with a theft resistant security hanger system from ArtRight purchased…
This table was built with unusually long legs to accommodate a tall altar cloth container underneath. The table is sturdily built with a pleasing undercut beveled overhang to maximize surface area. This table was challenging in that a dark stain was used along with an inlay that could not be stained. The water based finish…
Here is a small stepping stool for use in the chapel. I was shown some samples and given some dimensions. I got to work, did a quick hand sketch, and drew it up in Sketchup. Here’s what I ended up with after seeing a photo up on Fine Woodworking. I finished with General…
This creche, located in the rotunda at the State Capital building in downtown Atlanta, GA., was dedicated yesterday December 23, 2014 by Archbishop Wilton Gregory (on the right). It was built by Eagle Scout Patrick Smith (on the left) for an Eagle Scout project. Religious exhibits like this are allowed in public places. Patrick needed…
This is a recently completed portable altar. It was a total prototype after discussions with Father Mike on what he wanted. Probably have 80 hours into it total, maybe more. A lot of thought and trial and error went into how the 4 wings would fold up and how the 2 lower wings would be…
