Drying tray
Drying tray with waterproof epoxy coating for drying cruets after Masses. Made from red oak with walnut steam bent handles, inlay, and birch pegs topped with mother-of-pearl buttons.
Altar made with red oak A2 plain sliced plywood, and air dried quarter sawn red oak, with 24 way red oak match veneer sunburst. Red oak columns, capitals and carvings (hand carved), and crown gilding were done by Jorge Posada. Gold accents by Shannon Pable.
This table was built with unusually long legs to accommodate a tall altar cloth container underneath. The table is sturdily built with a pleasing undercut beveled overhang to maximize surface area. This table was challenging in that a dark stain was used along with an inlay that could not be stained. The water based finish…
This is a recently completed portable altar. It was a total prototype after discussions with Father Mike on what he wanted. Probably have 80 hours into it total, maybe more. A lot of thought and trial and error went into how the 4 wings would fold up and how the 2 lower wings would be…
Here is a small stepping stool for use in the chapel. I was shown some samples and given some dimensions. I got to work, did a quick hand sketch, and drew it up in Sketchup. Here’s what I ended up with after seeing a photo up on Fine Woodworking. I finished with General…
This interesting project was the result of being asked to install these 2 solid brass holy water fonts at the entrance to the chapel. The finish matches the dye/stain water based finish used on the altar and interior of the chapel itself. They were mounted with a theft resistant security hanger system from ArtRight purchased…
I remember a while back about how I was puzzled on how period furniture had parts of the inlay that were NOT stained dark, while the rest of the inlay and the furniture itself appeared to have a dark stain. How was that done? After some investigation on the internet and asking around, the answer…